10C Pro - Helmet Installation

Installing the Main Unit

Using the Clamp Unit

1. Loosen the two screws on the back plate of the clamp unit with the included allen wrench.

2. Insert the back plate of the clamp unit between the internal padding and external shell of the left side of the helmet.

3. Tighten the two screws until the clamp unit is fastened firmly to the helmet.

4. Insert a microSD card into the card slot to use camera.

5. Attach the main unit to the clamp unit until you hear a click.

 

Using the Glued Surface Mounting Plate

If you cannot install the clamp unit on the helmet, you can use the glued surface mounting plate to attach the clamp unit to the surface of the helmet.

1. Attach adhesive tape of the glued surface mounting plate to the helmet.

2. Make sure that the glued surface mounting plate sticks on the helmet firmly. Maximum adhesion occurs after 24 hours.

3. Attach the main unit to the glued surface mounting plate until you hear a click.

 

Installing the Speakers

1. Attach the hook and loop fasteners for speakers to ear pockets inside the helmet.

2. Attach the speakers to the hook and loop fasteners for speakers inside the helmet.

Note:

1. If the helmet has deep ear pockets, you can use the speaker pads to bring the speakers closer to your ears.

2. To enhance the audio quality, you can make use of the foam speaker covers. Cover each speaker with the foam and attach the hook fastener at the back of the speaker. Then place the speakers in the helmet as described above. Foam covered speakers work most effectively when
they are slightly touching your ears.

 

Installing the Microphone

- Using the Attachable Boom Microphone

1. Attach the hook and loop fastener for attachable boom microphone on the inside surface of the left external shell.

2. Attach the attachable boom microphone’s mounting plate to the hook and loop fastener.

3. Adjust the head of the microphone so that the tab is facing away from your mouth.

4. Align the arrows on the microphone and speaker cables and insert the microphone cable into the speaker cable.

5. Insert the speaker connector into the speaker port to connect it to the main unit.

6. Close the cover of the speaker cable to lock the cable to the port.

Note:

You can use the boom microphone holder after attaching the hook and loop fastener for boom microphone holder on it to ensure secure installation.

- Using the Wired Microphone

If you have a full face helmet, you can use the wired microphone.

1. Attach the included hook and loop fastener for wired microphone to the inside of the helmet’s chin guard.

2. Attach the wired microphone to the hook and loop fastener for wired microphone.

3. Align the arrows on the microphone and speaker cables and insert the microphone cable into the speaker cable.

4. Insert the speaker connector into the speaker port to connect it to the main unit.

5. Close the cover of the speaker cable to lock the cable to the port

 

Have more questions? Submit a request

0 Comments

Article is closed for comments.