How Do I Install the Prism onto a Motorcycle?

Prism_Motorcycle_Mounts.jpg

 

 

The Prism comes with the following QRM types for mounting the camera onto a motorcycle: The Handlebar Mount, The Top Surface Mount, and The Suction Cup Mount

 

To use the Quick Release Mounting system,

1. Screw the QRM Head to the screw hole on the bottom of the Prism using a flat head screw driver.

2. Insert the QRM Head into the QRM Body.

3. Slide the QRM Body Lock forward to lock the QRM Head into place.

 

The QRM head can also be used with the Waterproof Case that comes with the Sena Prism.

 

The QRM Handlebar Mount enables you to mount the camera on your motorcycle’s handlebar (between 7/8’’ and 1 1/2’’ diameter). You can choose the directions of the mounting arm and the U-bolt to best fit the mount on your handlebar. When you are not using the camera, you can take out the camera-attached QRM head from the QRM body.

 

The Handlebar Mount can be mounted on locations such as: The Handlebar, The Engine guard, The Frame guard, or a different location of your choosing.

 

The QRM Top Surface Mount enables you to mount your camera on a flat or curved surface. You can adjust the camera angle by rotating the ball joint on the QRM body. When you are not using the camera, you can simply separate the camera-attached QRM head from the QRM body.

 

The Top Surface Mount can be mounted on flat or curves surfaces such as: The Top Case, The Pannier Case, The Front Fender, or a different location or your choosing.

 

The QRM Suction Cup Mount enables you to mount the camera on surfaces that require some height for recording. You can adjust the camera angle by rotating the wheel joints or the ball joints on the legs. When you are not using the camera, you can simply take out the camera-attached QRM head from the QRM body. The QRM Suction Mount is interchangeable between using two suction cups or a single suction cup.

 

The Dual Suction Cup Mount or the Single Suction Cup Mount can be mounted on: The Pannier Case (Side Case), The Top Case, The Windshield, or a different location of your choice.

 

Note: When installing the Prism to a motorcycle, use the QRM wire to tie the QRM system to the motorcycle to protect it from any accidental falling.

 

Video:

 

Have more questions? Submit a request

0 Comments

Article is closed for comments.