SMH10R - Helmet Installation

To securely install the main unit of the SMH10R, you can use the hook and loop fastener or double sided adhesive tape. Please follow the procedure below.

1. Peel off the cover of the adhesive tape of the hook and loop fastener and attach it on the back plate of the main unit.

2. Locate a suitable surface on your helmet to attach the unit, clean the location with a moistened towel, and allow to dry thoroughly.

3. Peel off the cover of the adhesive tape on the hook and loop fastener and attach the fastener on the left side of your helmet.

4. Attach the main unit to the hook and loop fastener of your helmet.

5. You can also use double sided adhesive tape. Peel off the cover of the double sided adhesive tape and attach it to the back plate of the main unit. Then do the step 2 and peel off the other
side cover of the adhesive tape and attach the main unit on the left side of your helmet.

6. Place the speakers in the helmet along with the hook and loop fastener, centered to your ear, in the ear pockets of the helmet. If the helmet has deep ear pockets, you can use the speaker pads
to place the speakers closer to your ears. Attach the speaker connector to the 4 pin connector of the main unit cable.

7. There are two types of microphone that can be installed in your helmet. In the case of the attachable boom microphone, place the hook and loop fastener end of the boom microphone
between the internal helmet cheek pad and the internal wall of the helmet shell and attach the microphone connector to the 2 pin connector of the main unit cable. The boom microphone
should be mounted so it is positioned close to your mouth when you are wearing the helmet.

In the case of the wired microphone, attach the hook and loop fastener for the wired microphone to the inside of the chin guard for full-face helmets. Place the wired microphone on the hook
and loop fastener and attach the microphone connector to the 2 pin connector of the main unit cable.

8. Attach the double sided tape to the battery pack holder in the same manner as the main unit. Insert the battery pack down in the battery pack holder until you feel the click that signals
a secure attachment. Attach the battery connector to the 2 pin connector of the main unit cable. To get rid of the battery pack from the battery pack holder, push the battery pack upward.

 

 

Have more questions? Submit a request

0 Comments

Article is closed for comments.